PRESET BUTTON
– Press to cycle through the 4 presets (A/B/C/D) in the currently selected bank.
**SAVE FUNCTION**
Press both Bank and Preset buttons together to enter SAVE mode. Display will flash. Use Bank and Preset
buttons to choose a save location then press both buttons together again to Save the current UI state to
the selected preset location.
5
FEEDBACK KNOB
Sets the desired number of delay repeats. Turning the FEEDBACK knob clockwise
will give you more delay repeats, up to infinite. In Analog mode the delay will enter runaway feedback.
6
DELAY TIME KNOB
– Knob that controls the delay time. Using this knob overrides any preset Tempo
or Tap Value set by the tap footswitch.
7
TAP VALUE KNOB
– 4-way switch to set note division of the delay time.
8
THRESHOLD KNOB
– Knob to control the sensitivity of the Dynamic Expression feature. The LED will
illuminate brighter when there is more of the selected parameter blended in, and dim when there is less.
9
HARD/SOFT/OFF TOGGLE
– Toggles the Dynamic Expression between its two modes or turns it off.
HARD MODE – Blends in more of the selected parameter (Mix, Mod, or Saturation) when you play harder
SOFT MODE – Blends in more of the selected parameter when you play softer.
10
EXPRESSION ASSIGN BUTTON
– Selects the parameter that the Dynamic Expression feature
controls.
11
SATURATION KNOB
– Adds pleasant overdrive and ‘grit’ to the wet signal (repeats). This is similar to
tape saturation.
12
TONE KNOB
– Control to brighten or darken the sound of the wet signal.
13
MODULATION KNOB
– Blends in a Chorus effect on the wet signal.
4
