a
b
Should the cords ever become
detached please ensure when
replacing that they are aligned
vertically and that the clip on
cord toggles have equal tension
on each and they are level.
Cording the blind
For ease of assembling the headrail is pre-corded.
a.
With the split cord collector no less than 20cm from
the cord pulley and the blind layed flat, work from the
blind top. Where each cord will drop from the cord
guides, thread the cord vertically through the hole on the
rod bar cover. After the last bottom clip on rod, thread
a clip on cord toggle onto each cord.
b.
Using an upward motion as shown, thread the clip on
cord toggle into the last row of pocket tape.
Do not allow the cords to become twisted.
With the blind held in a level, vertical position, adjust the
clip on cord toggles so that equal tension is held on each
and they are level. Trim any excess cord at a distance of 4cm
from the clip on cord toggles.
Do not Knot the cords.
b
a
Positioning the cord guides along the back of the blind
a.
To position the cord guides push up release catch A,
slide to desired position, spaced equally and exactly
above a row of loops on the tape.
b.
Lock by pressing the catch back down.
Attaching the fabric to the blind
Line up the blind/loop tape with the hook tape on the
headrail and press firmly to secure the blind in place.
Retain these instructions for future reference.
Batch code:
CLRB001
