6
the power supply indicated on the nameplate of
the machine.
A Choose the plug as per the local regulation
and the plug must be equipped with the earth
terminator
；
B Check if the earth is effective
；
C The machine must be connected to the main
circuit with the multi-level circuit breaker switch
complied with CE standard. The distance to
connect is at least 3m.
D Check if the plug of the electrical cabinet
（
Fig
18
）
is connected correctly.
Fig 18 Electrical cabinet
E After connect the circuit of the machine, connect
the switch to check if the rotation direction of the
hydraulic unit is corresponding with Fig 19;
Fig 19
Construction drawing A
F If the rotation direction of the oil pump motor is
reverse, exchange any two phase at the power
plug
；
G If the running of the machine is abnormal, you
should immediately switch off the power switch(No
15 in Fig 19
）
and check the reason of the
troubleshooting and repair.
The manufacturer will not be responsible for
the damage due to the above reversal connect
of power cable
2 Pneumatic connection
As per Fig 20
Fig20 Air regulator
Safety protection label
：
When operate, you should pay attention to the
warning label on the machine.
A Warning the drop off of the wheel;
B Warning the tool head may rotate.
C Warning the chuck may rotate
C Warning the tilt of the chuck arm and tool arm
外接气源接头
DTM590
DUNLOP GARAGE EQUIPMENT
