DTSL3/FR MKII USER’S MANUAL
12
Chapter
Chapter
Chapter
Chapter 3
3
3
3 SAFET
SAFET
SAFET
SAFETY
Y
Y
Y
RISKS FOR PERSONNEL
This heading illustrates potential risks for the operator, maintenance fitter, or any
other person present in the area around the lift,
result from incorrect use of the lift.
RISKS FOR EXTRUSION
During up and down operations, personnel leave the said area without following the rule and instruction.
During up and down operations, no person is admitted to work beneath the movable parts of the lift, should work in the safe zone.
(Picture 5).
RISK OF IMPACT (Picture 10)
Before the operator begins up and down movements, make sure that there are no personnel inside the danger zone. When,
due to operational reasons, the lift is stopped at relatively low elevations (lower than 1.75m above the ground) personnel
must be careful to avoid impact with parts of the machine not marked with special colors.
RISK OF FALLING OFF (PERSONNEL)
During up and down operations, personnel are prohibited from entering the platforms and the vehicle to avoid falling off.
RISK OF FALLING (VEHICLE) (Picture 11)
This hazard may arise in the case of incorrect positioning of the vehicle on the platforms, overweight of the vehicle, or in the case of
vehicles of dimensions that are not compatible with the capacity of the lift.
When the platform is being tested, the vehicle engine can not be turned on.
There is nothing should be placed on the lift-lowering area and the movable parts of the lift.
RISK OF SLIPPING (Picture 12)
The floor caused by lubricant contamination of around the lift. The area beneath and immediately surrounding the lift and also the
platforms must be kept clean. Remove any oil spills immediately.
RISK OF ELECTRIC SHOCK
Risk of electric shock of the areas of insulated in electric equipments were shattered.
Do not use jets of water, steam solvents or paint next to the lift, and take special care to keep such substances clear of the electrical
control panel.
RISKS RELATED TO INAPPROPRIATE LIGHTING
The operator and the maintenance fitter must be able to assure that all the areas of the lift are properly and uniformly illuminate
compliance with the laws in force in the place of installation.
During up and down operations, the operator should continually observe the lift and can
operate it only in the position of operator.
When lifting and lowering the vehicle, the cushion needs being put in the bottom of chassis.
The handling of safety devices is strictly forbidden. Never exceed the maximum carrying capacity of the lift, make sure the vehicles
to be lifted have no load.
It is therefore essential to adhere scrupulously to all regulations regarding use, maintenance and safety contained in this manual.
Picture 10
Picture 11
All manuals and user guides at all-guides.com
