L.AMA.10.C.L
Volkswagen AMAROK
14
DUNLOP and the Flying D Device are trademarks of Dunlop International Group and are used under license by DSC Nederland B.V.
www.dunlopsystems.nl
5.9 Maintenance
Following installation, it is recommended that all metal parts are coated
with a protective substance such as body wax.
The system does not require very much maintenance other than…
to maintain air pressure in the springs. Much like a tyre, the system
may lose a little air over time.
to keep the air bellows clean. It is suggested that, when washing
the vehicle, the bellows are inspected and cleaned as necessary
(preferable by spraying). Look in particular for stones or grit
trapped between convolutes, as this may damage the bellow.
Check before and after the winter period the wax coating. Re-wax
when necessarily
5.8 Spring Alignment
i.
With the vehicle standing at the desired ride height, ensure that the
springs are correctly aligned as illustrated above and then tighten
the bolts to secure the bellow to both the upper and the lower
mounting brackets.
ii. Always check if the air bellow won’t touch any obstacle
Spring out of alignment
mounting plate axes
offset
Spring in alignment
mounting plates parallel
and coaxial
