Ignition
An additional positive ignition wire (White) can be connected to indicate engine status. This is used to log
accumulated ‘engine hours’ for service intervals & maintenance purposes. The ignition signal creates trip
start/stop indications. Note that even if the ignition wire is not connected, the device map label will still
indicate ignition ‘active’ when movement is sensed.
Anti-Tamper
The yellow wire is a negative digital input configured as a ‘normally closed’ loop. This should be connected to
the supply negative (black wire). A loop between the two terminals can be extended to attach to items like
Outboard Motors on boats. If the wire is cut by removing the motor, an immediate ‘anti-tamper’ alarm will be
generated. When the loop is closed, the map label will show ‘OK’
External Power
When connected to an external power source such as a vehicle/boat battery, the supply voltage will be
indicated with each tracking report received, so can be used to monitor levels in real time. An alert can be set
to a threshold of your own choosing. ‘Power disconnect’ alerts may be used to indicate the tracker has been
removed during a theft attempt, in addition to anti-tamper messages.
Device Status LEDs
