JET VAC ECO
7. OPERATING INSTRUCTIONS
(a)
After opening the packaging box eventually fix the machine on the trolley.
(b)
Plug the power cord (20) into the electric socket (10) and verify that the vacuum power switch (18) is in ON
position.
(c)
Lift the tank cap (11) and add water to the water tank,
we recommend to exclusively fill in water only, any
other liquid may damage the generator permanentely
.
(d)
Insert the plug (1) into an electrical outlet, making sure that the voltage and the amperage correspond with those
printed on the plate of the machine (on the inferior part).
WARNING
WHEN THE W ATER TANK IS EMPTY THE LOW WATER INDICATOR (2) SW ITCHES ON AND THE STEAM
OUTPUT WILL BE DISABLED UNTIL WATER IS BEING ADDED TO THE WATER TANK (9).
PLEASE NOTE: THIS OPERATION CAN BE CARRIED OUT W ITHOUT SW ITCHING OFF THE MACHINE.
USE OF THE ACCESSORIES
Insert the vacuum hose (30) into vacuum hose outlet (13) and the steam plug (32) into the steam outlet (6) found
on the front of the machine. Push until the latches (14 and 31) lock into place.
Activate the power switch (4) and the boiler switch (5) for the production of steam and wait approximately 5
minutes until the green "ready steam" indicator (3) on the command switch lights up indicating that the boiler has
reached the operating pressure. The switches (35,36 and 37) located on the handle should be in OFF position.
When the indicator (3) lights up, position the switches (36 and 37) on the handgrip to regulate the steam flow as
follows: switch (36) minimum flow, switch (37) medium flow, switches (36) and (37) maximum flow. Use the security
trigger (34) to activate the steam flow.
The vacuum switch (38) activates the vacuum and can be used simultaneously with steam, the power can be
regulated by pressing the + and – symbols on the electronic regulation (12) on the vacuum head.
The switch (35) enables you to inject overheated water with the steam by activating it for a few seconds at a time
to avoid exceeding the injected liquid to the steam.
To clean with the combination of steam, injection of overheated water and vacuum suction choose the accessory
best suited for the job:
Warning!!
By pushing the switch (35) overheated water under pressure with a temperature, according to the model, of
up to 180 °C will come out of the lance. Please be careful not to action this switch without alert and do not
align the jet towards persons or animals.
To clean with the combination of steam, injection of overheated water and vacuum suction choose the accessory
best suited for the job:
The multi-purpose floor tool (51): with appropriate inserts (53,54,66,67). Inserts are locked into place by sliding the
latches (52) to the OPEN position and hold the insert in place applying a little pressure while sliding the latches in
12 DUPLEX (UK)
