145
m
Drum Section
chap.3
(2) Removal of Master Clamp
(3) Removal of Base Unit
1) Remove the screen.
2) Remove 2 screws on the operation side.
3) Remove the bearing plate and spring.
4) Remove 2 screws on the anti-operation side to
take out the bearing plate.
5) Remove the master clamp. The master clamp is
attached to the base with the magnet.
\
See page 144
Adjust the master clamp after
installation.
\
See page 177
IMPORTANT :
1) Remove the master clamp.
2) Remove 2 screws, and remove the base unit.
Reinstallation
Screw
Screw
Screw
Screw
Bearing plate
Spring
Master clamp
Base unit
Summary of Contents for Duprinter DP-330
