160
x
Platemaking / Master Feed / Ejection Section
chap.4
u
Shift
y
Stop in front
of lever
(3) Adjusting the A / B / C Mode
¡
For description of operation.
\
See page 56
NOTE :
1. Adjustment for B mode
Adjustment procedure
1) Remove the drum from the machine body.
2) Access HELP mode H-02.
For basic HELP mode procedures.
\
See page 219
HELP mode H-02
\
see p.227
3) Press and hold down the
"CURSOR " PRINT-
ING SPEED ADJUSTMENT
key, until the master
clamp open/close lever moves into the
"more
open than B mode (toward C mode) position"
(see right).
4) Turn the power off, then on again.
The master clamp switch lever will move into the
B mode position and stop there.
5) Turn off the power, and install the drum to the
machine body.
6) Open the plate ejection box. Then press the
JOG
switch (drum rotator switch)
to move the master
clamp to a position in front of the open/close
lever, and stop it there.
7) Move the master clamp, paying attention to the
clearance at the same time.
WARNING
¡
Do not touch the drum or rolls when operat-
ing the JOG switch.
¡
Do not put your hands or fingers inside the
machine during operation. They could be
caught up or crushed in the machinery,
resulting in injury.
B mode
C mode
¡
More open than B mode (toward C mode) position
¡
When drum is removed from main body (A mode)
Summary of Contents for Duprinter DP-330
