57
2
Adjusting Feeder
Basic Operations
3
If the
fi
nished products are cut obliquely, adjust the
skew using the skew adjustment knob.
Skew Compensation
Press the TEST key to perform a test run for one
sheet and check the
fi
nished products.
Clockwise : Turning the knob slightly shifts the
lead edge of the document toward the
operator's side.
Counterclockwise : Turning the knob slightly shifts the
lead edge of the document toward
the non-operators side.
If the skew remains, repeat the above steps 1 and 2 again.
Summary of Contents for DC-6 Mini
