Programming a JOB on the Control Panel
32
The following items should be entered to program a JOB.
JOB number
Select a JOB number in which the JOB currently being programmed is saved.
JOB name
Enter a JOB name using the NUMERIC keys.
Select Module (Module selection in slot 2 to slot 4)
Select modules to install in slot 2 to slot 4.
Select Tool (Displayed when using optional rotary tool module and/or optional cross tool
module)
Select a tool of the modules
to install
in slot 2 to slot 4.
Width
Enter the width of a document.
Length
Enter the length of a document.
REG mark position
When using
the
REG mark reading
function
:
Enter the distance between the lead edge of the document and the REG mark and the distance
between the right edge of the document and the REG mark.
REG mark spec
This sets a reading function for a bold REG mark printed on a specially treated document.
(
→
P.23 IMPORTANT)
Read REG mark
This sets an operation mode when
REG mark is detected
. Reading the REG mark and
correcting the print position gap improve accuracy of document processing.
Slit position
Enter the distances between the right edge of the document and each slit position.
The DC-646 can slit up to
six
positions on one document. (can slit up to eight positions when
the optional slitter modules are installed.)
Cut trim mode
Lead margin, trail margin, and any gutter cuts (48.9 mm or shorter) are chopped up and
dropped into the waste box.
If there is no lead margin or trail margin on the document, select
No bleed mode
.
Cut position
Enter the distances between the lead edge of the document and each cut position.
The DC-646 can cut up to 30 positions on one document.
Crease position (Perpendicular to the document feed direction)
Enter the distance between the lead edge of the document and each crease position.
The DC-646 can crease up to 20 positions on one document.
