30
10. FOLDING MISALIGNMENT
Adjustment registration procedure
The adjustment value of folding misalignment along the vertical length of the paper can be
registered using the adjustment registration key.
A total of 30 different adjustment values can be registered (6 standard folding modes
×
5
standard paper sizes (LGR, LGL, LTR, STMT, and INV)).
By registering adjustment, no adjustments need to be performed when performing folding
operations under the same conditions (paper, folding mode, processing speed, etc.) as those at
registration.
The adjustment registration function cannot be used for standard folding of non-standard paper and custom
folding. Use the custom folding registration function.
Note
Note
Stack paper on the paper feed tray, and
set the paper feed guides.
1
Check for folding misalignment along
the vertical length of the paper from the
test folding results.
Check for folding misalignment using the second test
folded sample.
4
Fixing screw
Paper feed guides
Press the folding mode key to select
the folding mode.
Each time the folding mode key is pressed, the
standard folding lamp lights up in order towards the
right. Folding modes whose lamps are blinking
indicate that adjustment registration has been
performed.
2
Standard folding lamp
Press the test key to perform test
folding.
Test folded paper are not counted in the number of
sheets processed.
3
Folded paper
Correct folding misalignment along the
vertical length of the paper using the
folding stopper adjusting keys of
folding plates 1 and 2. (
☞
p.27)
5
A f t e r a d j u s t i n g t h e f o l d i n g
misalignment, press the adjustment
registration key until the buzzer
sounds “pi.pi...” (about two seconds).
When adjustment registration completes, the lamp of
the folding mode selected stops lighting and starts to
blink.
The adjustment value data registered is preserved
even after the power is turned off.
6
Blinking (End of adjustment registration)
