56
Release the lock lever, and remove
folding plate 1.
2
Be sure to hold folding plate 1 with both
hands.
Do not subject folding plate 1 to shock,
otherwise it may damage, folding
accuracy will drop.
Note
Note
21. CLEANING THE UNIT
The adherence of paper dust, printing ink, etc. on the folding rollers, paper feed rings causes
problems such as paper feed errors, folding misalignment, etc. Clean as follows.
Prior to cleaning, be sure to disconnect the power cord from the outlet.
After cleaning, make sure that the areas that were cleaned are completely dry before resuming paper folding
operations.
After cleaning, be sure to close the top cover properly. If not closed properly, the unit will not operate.
Note
Note
21-1. Cleaning
the Folding Rollers
Remove folding plate 1 to clean the folding
rollers.
No.1 connector
Control cord 1
Lock lever
Folding plate 1
Top cover
Folding roller
Jam correction knob
Disconnect control cord 1 of folding
plate 1 from the No.1 connector.
1
Open the top cover.
3
While rotating the folding rollers with
the jam correction knob, clean them
with a cloth moistened with alcohol.
4
Close the top cover.
8
Set folding plate 1 back to the original
position.
5
Push the lock lever towards “LOCK”,
and insert control cord 1 into the No.1
connector.
6
Rotate the jam correction knob to
check that folding plate 1 is secured. If
the knob rotates smoothly, it means
that folding plate 1 is secured.
If not secured properly, the LCD will show “F.PLAT-1
SET ERR” when the power is turned on.
7
Do not use flammable sprays or solvent inside or near the unit (e.g. when cleaning the
unit). Such flammable gas may ignite and cause a fire or combustion. Take precautions
against fire and ensure ventilation when using alcohol, and store the alcohol in a safe
place after use. Also note that use of other solvents can damage the rubber rollers and
resin inside the unit, resulting in malfunctions.
WARNING
!
