- 33 -
Error Message and Trouble Shooting
Error Message
Trouble Shooting
Miss Feed
1.Check S1 voltage
2.Check feed motor belt
3.Check pulley screw
4.Check motor detent torque, if no torque
5. Replace driver board
Jam in Sensor 2
1.Check S2
2.Adjust the feed tray tension
3.Adjust the ramp
4. Check transport motor has detent torque
Jam in Sensor 3
1. Check S3
2. check detent torque of transport motor, if no
torque
3. Replace driver board
Mark error
1. Check mark sensor voltage; see paper 0.2V
2. Seeing mark has to be greater than 1.8V
3. Change mark sensor and do mark, top margin
calibration
Check Top Cover
Check top cover interlock switch
Check Rear Cover
Check rear cover interlock switch
Check Waste Bin
Check waste bin interlock switch
Finish card not clean and neat
1. Adjust the cutting knife guiding plate, if
problem still
2. Replace cutting knife
Finish card length uneven
1. Adjust the cutter Assy. frame mounting screw
on the side plates
2.Check driving belt tension
Bar Read Error
Replace S4
Cutter Error
1.
Turn the cutting knife crane plate, if no
detent torque, replace driver box
2.
Driving crane screw loose, if not
3.
Sensor goes bad
Top margin not even left and right
Adjust the side guide, make sure it is right angle
to the first set of roller
Transport no function
Rotate transport motor on the side frame, if no
detent torque, replace driver box
Slitting not good
Replace the slitter
Summary of Contents for DocuCutter CC-228
