48
8. NO-STITCHING FOLDING PROCEDURE
207 . 0
1
Next key
Trimming width
Back key
<Set Trimming Position> Screen
420. 0
x
297 . 0
210. 0
x
297 . 0
Back key
Return key
<Confirm Settings> Screen
00000
01
420. 0
x
297 . 0
210. 0
x
297 . 0
Size change key
<Main Menu> Screen
MAINMENU
ADJUST
OPTION
ACCESSOR
Perform paper size change
Step
3
8-2. Changing Size
Press the [Size Change key] for more than one second to
change the size.
When size change completes, a beep sounds.
Note
Note
This machine moves left and right.
Confirming settings
Make sure that the values entered are all correct, and then
press the [Return key] on the touch panel.
Pressing the [Return key] saves the settings of the
memory number and returns to the <Main Menu> screen.
Pressing the [Back key] returns to the <Set Trimming
Position> screen when set to “Trim On”, and returns to the
<Enter Paper Size> screen when set to “Trim Off”.
Setting the trimming position (When set to “Trim On”)
(As the paper is not stitched, paper may deviate while trimming)
This is the finished length after trimming.
When the paper length is entered, the standard trimming
position will automatically be displayed.
∗
Standard trimming position: (Paper length
÷
2) – 3 mm /
0.12 inch (MAX: 253 mm/9.96 inch)
Here, it is displayed as “207.0/8.15” (400
÷
2) – 3 = 207.0/
(16.54
÷
2) – 0.12 = 8.15.
If not changing this value, proceed onto the next step.
To change the finished length, press the box
1
to reset
the value displayed to 0, and enter the desired value.
Range of input: 75.0 to 253.0 mm/2.95 to 9.96 inch
(Trimming width within 78 mm/2.95 inch)
Press the [Return key] to confirm the value.
Pressing the box again while entering the value returns to
the original value.
After entering the trimming position, press the [Next key]
to proceed to the <Confirming settings> screen.
Pressing the [Back key] returns to the <Enter Paper
Size> screen.
Step
4
