53
8. NO-STITCHING FOLDING PROCEDURE
Lock nut
Trail edge
Booklet
Knobscrew
Folding back guide roller
Locknut
Knobscrew
Folding back guide roller
Folding misalignment may also occur if the folding side guides are too narrow or wide.
Perform adjustments in the step mode again, and check the positions of the folding side guides. (
Refer to page 51.)
If the booklet rides onto the folding side guide or jams, gradually increase the value of “stitching side jogger open timing”
on the option menu. The standard value is 0. (
Refer to page 61.)
However, paper may jam at the stitching section if too many sheets of paper are fed.
Adjust the position of the folding back guide roller.
Loosen the locknut, and move the folding back guide roller to the trail edge using the knobscrew.
This holds down the booklet and prevents folding misalignment.
When booklet alignment is poor at the belt stacker
Change the conveyance time of the belt stacker at accessory menu. (
Refer to page 65.)
If there are too many sheets, or when paper is thick, set a long conveyance time.
If booklet alignment is still poor after adjusting the conveyance time, replace the paper guide wheel with one for large
size paper. (Not available for paper less than 121 mm/4.76 inch.)
If booklet alignment is still poor, loosen the knob screw and move the paper guide wheel to the main body.
❊
Single insertion binding
Single insertion means single folding A3 (LD) paper and inserting one sheet of A4 horizontal (LT horizontal) paper during
non-stitching binding. The single insertion binding procedure is as follows.
1
Replace the conveyance roller with the sponge roller
unit provided.
2
Set the DC-10/60 overlap to 3 so that the inserted
paper is transported to the DBM-500 in first.
(Refer to the DC-10/60 instruction manual.)
Remove the screw, pull out the conveyance roller unit in the
arrow direction, and replace with the sponge roller unit.
Remove screw
Conveyance roller unit
Sponge roller unit
Conveyance roller
Remove in arrow
direction
