English
- 49 -
Remote Control Handset
Inserting Batteries
•
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
•
Insert two
AAA/R3
or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
+
+
- -
Note
: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
•
Connect the power cord to the 220-240V AC 50 Hz.
•
Then the standby LED lights up.
•
To switch on the TV from standby mode either:
•
Press the “
” button,
P+
/
P-
or a numeric button on
the remote control.
•
P Press the control switch right side of the TV. The
TV will then switch on.
Note
: If you switch on your TV via PROGRAMME UP/
DOWN buttons on the remote control or on the TV
set, the programme that you were watching last will be
reselected.
By either method the TV will switch on.
To Switch the TV Off
•
Press the “
” button on the remote control or hold
the control switch on the Tv until shut down , so the
TV will switch to standby mode.
•
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.
Standby Notiications
If the TV switches off while in No Signal mode, the
following on-screen message will be displayed on the
next switch-on:
When the Auto Tv Off timeout is reached, the following
message will be displayed on the screen. Select YES
to shut down the TV. Select NO to cancel. The TV
will switch off as well, if you do not make a selection
on this screen.
If the TV switches off owing to the auto power down
feature, the following on-screen message will be
displayed on the next switch-on:
Digital Teletext (** for UK only)
•
Press the “
” button.
•
The digital teletext information appears.
•
Operate it with the coloured buttons, cursor buttons
and
OK
button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on digital teletext
screen.
•
When Press “
SELECT
” button or similar message
appears on the screen, press the OK button.
•
When the “
” button is pressed, the TV returns to
television broadcasting.
•
With digital terrestrial broadcasting (DVB-T), in
addition to digital teletext broadcasting together with
the normal broadcasting, there are also channels
with just digital teletext broadcasting.
•
The aspect ratio (picture shape) when watching
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.
•
When you press the “
” button again, the digital
teletext screen will be displayed.
Summary of Contents for 7702855
Page 116: ...50234816 ...
