Version 20190806 Page
7
LEARNING TRANSMITTER TO RECEIVER
Each transmitter has a unique RF code. To have the receiver box to accept the transmitter’s signal (code), be sure the slide
switch button on the receiver is in the REMOTE mode.
Find the LEARN button on the front face of the receiver (Fig. 16) Use a small screw- driver gently press the black LEARN
button inside the hole. Then the receiver box will
sounds of quick BEEP X 2 ( ♫ , ♫ )
. And press the MODE button on
transmitter . The receiver box will beep to indicate that the transmitter’s code has been captured by the receiver.
If you fail the LEARNING of matching the security code, please wait 2 minutes before another try. The interval allows the
microprocessor in the receiver box to reset itself and available for accepting new code. Please try more times.
Any questions, please email us.
Fig. 16
SYSTEM TESTS & CHECK LIST
MILLIVOLT VALVES
Please DO take following tests and make sure all functions are working fine:
1. Slide the slide switch button on the receiver to the ON (Fig. 16). The main gas fire flame should ON.
2. Slide the button to OFF. The main gas fire flame should extinguish and the pilot flame will remain ON.
3. Slide the button to REMOTE, and press the MODE button on the transmitter to change the system to ON. The main
gas fire flame should ON.
4. Press the MODE button on the transmitter to change the system to OFF. The main gas fire flame should extinguish
and the pilot flame will remain ON.
5. Press the MODE button on the transmitter to change the system to THERMO
*2
mode. Make the SET temperature on
the transmitter to a temperature of a least 2
°
F (1
°
C) above the ROOM temperature displayed on the LCD screen, the
system flame and main gas fire flame will be ON. Then make the SET temperature to at least 2
°
F (1
°
C) below the ROOM
temperature, the system flame and main gas fire flame will extinguish in seconds. It should continue to cycle ON and OFF
thermostatically. The temperature differential between ROOM and SET temperatures differ at least 2
°
F (1
°
C) to start the
THERMO
*2
cycling. (The 2
°
F differential is the factory setting, can NOT be changed.)
