Durabrand PH-543, Operating Instructions Manual

IB-PH543(168F)-WM-E-051203

NOTE

:

1. If problems with your telephone service occur later, try to

determine if the trouble is with the telephones you own or with

the telephone company equipment. Unplug the telephone and

try it on another jack in a different room or in a neighbor’s home

to see if the phone line or the set is bad. If the known working

phone does not operate properly on that line, contact your local

telephone company for assistance.

2. If disconnection of your phone ends the problem, your phone

may be the source of the trouble and it should be tested and

repaired if necessary before it is reconnected.

3. There are no user maintainable parts or adjustments on this

set. Should your phone require repairing, contact the

manufacturer for instructions (except for cords which you can

buy at any phone store).

TROUBLE SHOOTING 

(continued)

PROBLEMS

CHECK

Pick up the phone before the second ring,

or your phone received no information or

unclear information. Static can cause this

message. If this condition persists, contact

your local telephone company to ensure

there is no problem with your phone line.

Shows in the

display

Cannot erase

all records in

memory

The DELETE button must be quickly pressed

twice to erase a single call record. To erase

ALL 

call records, display any record using the

UP or DOWN button, then press and hold the

DELETE button for about 6 seconds

after you 

viewed all new calls

.

Your language is set for French or Spanish.

To reset the language, press and hold the

DELETE button and then press the DOWN

button. While “  ” is flashing, press the

DELETE button to confirm. The language will

be set to English mode.

Caller ID dis-

plays words like

 or

 or 

 or

or 

Memory Dialing

does not work

Check if you have stored the numbers

correctly by pressing that memory location

button(s). Also numbers can only be stored

when fresh batteries are installed.
The caller may have a blocked number to

prevent Caller ID identification, or it may be

an overseas call or you may have noise on

the line during that call.

Caller’s number

is not registered

to the Caller ID

memory

Check with your telephone company if this

service is available and if you have

subscribed for it.

Message Wait-

ing does not

work

The MEMORY button has no stored number.

Please store the number again. Press the

STORE button, dial the number and then

press the MEMORY locations.

Pressing a

MEMORY button

not display

stored number

15