30 |
P a g e
DG66M-R62, -B62 & DG67M-R62, -B62
6. As the engine warms up, move the Choke Lever to Closed/Off
position as shown by the arrow:
7. Allow the engine to warm up for 2 minutes before plugging
electrical devices into your generator.
8. Confirm that each electrical device has been turned OFF before
plugging it into your generator.
WARNING:
The engine exhaust from this product contains carbon monoxide gas. Breathing this poisonous gas,
which is odorless and colorless, can cause unconsciousness and even death.
Monitoring the fuel level
When adding fuel, turn the generator off and let it cool
at least 2 minutes before removing the gas cap.
After waiting for 2 minutes, remove the fuel tank cap and
check the fuel level.
Refill the fuel tank if the fuel level is low but do not fill above
the upper level mark.
Using caution when refueling the tank
After refueling, tighten the fuel tank cap securely and wipe up any gasoline that may have spilled:
Fuel can damage components of your generator such as metal, rubber, paint, and plastic.
Note: Damage caused by spilled fuel is not covered under warranty.
Fuel vapor is highly flammable and could ignite after your generator is started. After
refueling, wipe up any spilled fuel before restarting your generator. Store your gasoline
away from sparks and flames.
Check the level of your generator’s fuel tank every time before starting it. The fuel level
must be between the minimum and maximum capacity lines.
Summary of Contents for DG66M-B62
