Duracell DG66M-B62 Owner'S Manual Download

Page: 34 / 60

32 |

P a g e

DG66M-R62, -B62 & DG67M-R62, -B62

and its systems can be performed by any engine repair establishment or repair person, using parts that
are certified to EPA standards.

Note:

Your Authorized Service Dealer is knowledgeable about your generator, and is best

equipped to maintain and repair it. To ensure smooth, economical, and trouble-free operations,
use only new, genuine Duracell generator parts or their equivalents when repairing your
generator and replacing its parts.

Maintenance safety precautions

Critical safety precautions are summarized below. Read the maintenance instructions before you begin
and confirm that you have the necessary skills and proper tools to perform the procedures.

Since we couldn’t possibly warn you of every possible hazard that could arise while maintaining your
generator, it’s essential that you use good judgment when deciding which procedures should be
performed and use care when performing the procedures.

Turn generator off before servicing:

Confirm that your generator’s Engine Switch is turned to the OFF

position before beginning any maintenance and repairs.

Exhaust contains carbon monoxide

: Never operate your generator in an enclosed or partially enclosed

area. Be sure there is adequate ventilation. The engine exhaust contains carbon monoxide, a poisonous
gas that is odorless and colorless. Be sure to have adequate ventilation when operating your generator
and never allow the gas to build up.

Generators get extremely hot

: To avoid severe burns always allow the engine and the exhaust system

to completely cool before touching, moving, and storing.

Gasoline is flammable

: Use extreme care when working with gasoline to avoid the possibility of fires and

explosions. Use only nonflammable solvents when cleaning parts. DO NOT use gasoline to clean your
generator’s parts. Keep sparks, cigarettes, and flames away from all fuel, your generator, and any fuel-
related components.

Check cooling holes:

There are cooling holes on your alternator. If these cooling holes become

blocked, your generator could overheat and cause damage to the engine, inverter, or windings. So, when
you inspect your generator before and during use, it’s critical that you keep these cooling holes open and
clear of mud, water, paper, or other debris.

Keep your generator upright:

Never lay your generator on its side while moving, storing, or using it. Oil

could leak and damage your generator’s engine and surrounding areas.

Comply with local and current regulations:

There may be local codes, ordinances, or federal or state

Occupational Safety and Health Administration (OSHA) regulations that apply to the use of your
generator. Consult a qualified electrician, electrical inspector, or your local agency. For example, some
areas require that generators be registered with the utility companies. There may be additional
regulations that apply if your generator is used on construction sites.

Failure to follow maintenance precautions, procedures, and
guidelines can cause you to be seriously injured or killed.