E L E C T R I C A L
R A T I N G S
This product is rated at
120 Volts A.C., 60 Hz with
a power consumption of
135 Watts. The ionization
voltage is 7500 Volts D.C.
C A R T R I D G E
R E P L A C E M E N T
F I L T E R
C A R T R I D G E
R E P L A C E M E N T
NOTE: Neither the pre-
filter nor the HEPA filter
are washable.
Step 1:
Turn the Air
Cleaner off and unplug
from the wall outlet.
Step 2:
To open, gently
place the air cleaner on
its side and unscrew the
locking handle under its
base to release the BASE
from the air cleaner.
Step 3:
Remove the
BASE assembly.
Step 4:
Remove the filter
assembly (consisting of
the HEPA and pre-filter)
from the internal chamber.
Step 5:
Locate the seam
of the pre-filter and care-
fully separate the fastener
on the seam from the pre-
filter and remove the pre-
filter from the HEPA filter.
IF REPLACING ONLY THE
PRE-FILTER, SKIP TO STEP 7.
Step 6:
Discard Pre-filter
and HEPA filter. Remove
any packaging and plas-
tic from the HEPA filter.
Step 7:
Remove any pack-
aging or plastic from the
new pre-filter and remove
any additional fasteners
from the box. Secure
approximately 1/2 inch of
the strap fastener to one
edge of the carbon
pre-filter (on the white
side). Carefully wrap the
pre-filter around the HEPA
filter so that the ends meet
and the white side is
facing outwards. Fasten
the ends together with
the strap fastener.
Step 8:
Place the whole
filter assembly into the
product chamber. Close
the product by replacing
the base and tightening
the locking handle.
Step 9:
Turn the air
cleaner upright, plug into
wall socket and turn on.
Step 2
Unit
Base Locking
Handle
HEPA Filter
with Pre-Filter
Step 5
Step 7
