9. Sleep function
When there is no operation for more than 10 minutes at the stop, the system turns off all displays
and goes to sleep. Press any key to wake up.
10.General failures and troubleshooting methods of the control system
The following is the error code and solution for the electronic watch:
E01: The information fed back to the electronic watch by the controller is blocked.
Solution: Check if the connector of the 4-wire cable connected to the controller is loose or damaged.
E02: The controller does not detect the voltage on the motor line.
Solution: Check if the positive and negative motor wires are securely connected to the terminals on
the controller.
E05: The current is too high when the motor is running, exceeding the rated current.
Solution: Please check the motor for damage or contact the after-sales service personnel for
technical support.
E07: The MTC did not detect the signal of the safety lock.
Solution: Please check if the safety switch is fastened, fasten one end of the safety switch to the
treadmill and the other end to the user's clothes.
E09: MTC communication is interrupted.
Solution: Please turn off the power and restart the treadmill. If the problem persists, please contact
the after-sales engineer.
11. Daily maintenance Electric
treadmill maintenance
Proper maintenance is the only way to keep your treadmill at its best. Wrong maintenance can hurt
or shorten the life of your treadmill.
Important reminder:
- Do not use sandpaper or solvents to clean the treadmill. The controller part of the treadmill should
not be exposed to direct sunlight or moisture to avoid damage.
- Always check and lock all parts of the treadmill, replace those defective parts immediately and/or
leave the equipment idle for repair.
Adjusting the running belt
Adjusting the run has two functions: elastic adjustment and running center position adjustment. The
running belt has been adjusted at the factory, but after use, the running belt will be stretched, which
will cause the running belt to rub against the center strip and the rear cover to be damaged. It is
normal for the running belt to be stretched during use.
- 10 -
Summary of Contents for DFIHE002
Page 20: ......
