GraphicProducts.com | 800-788-5572
Battery (Optional) |
13
BATTERY (OPTIONAL)
Toro Max’s battery is an optional accessory. The Lithium-Ion (Li-ion) battery lets
you design and print labels on the go, even without an AC power supply. Typically,
a fully-charged battery will allow for up to 3 hours of use in the field.
Battery Loading
The battery mounts into the back of the Toro Max. Remove the battery cover door by
pushing the slider downward and pulling the door away. Position the battery so the
cut-outs are aligned and the contacts are in position with the contact interface. Push
the battery in until it locks into place, and return the battery cover door to its position.
Charging the Battery
The Toro Max battery charges automatically while it is loaded into the printer and the
system is plugged in with its AC Adapter. Charging will continue whether the system
is powered on or off, and will stop automatically when the battery is fully charged. No
separate charger is needed, and the battery does not need to be removed from the
system. The battery can usually be fully recharged in about three hours.
Battery Maintenance
Because Lithium batteries self-discharge over time, it is recommended that you fully
recharge the battery at least once every three months. When the battery is not in use,
keep it in a cool, dry place, away from heat or direct sunlight. Do not disassemble
your Toro battery. Do not let the metal battery pins come into contact with another
metal surface. If you notice any unusual odor, leakage, or swelling in the Toro battery,
discontinue use and contact your DuraLabel representative.
Older Batteries
If you have a battery for the original DuraLabel Toro system,
do not
use it in the Toro
Max, as the older battery was designed to use a separate charging system. Contact your
DuraLabel representative for more information.
7
