9
Operating Your Cleaner
If this is the first time you are using the cleaner, please read this whole section
before operating your cleaner!
1. Plug in your machine and flip on the On/Off control switch in the back of the unit.
2. Fill the machine with your water/chemicals. Pay close attention to the
directions for temperature and duration from the chemicals SDS information
paperwork (Included in your package or available on our website).
3. Remove the basket put the lid back on the unit..
4. Firs
t set the desired temperature by pressing the up arrow “temperature
button” Second set the ultrasonic cycle time by pressing on the time up
arrow “time button”. After setting the temperature and the time, press the
ON/OFF middle button to start the unit.
5.
Keep the basket out and the lid on while it is heating up to quicken the
waiting period. You can also run the ultrasonic for an additional 10
degrees per hour.
6. Place the basket back into the unit with parts for cleaning.
7. When the cleaning cycle is complete, you can rinse the parts in the sink, and
dry. Strain the chemicals with a cheese cloth to keep them fresh for the next
cleaning.
If you are removing oils, you can find an “oil diaper” online for
reasonable price and quantity. This can be placed on the water surface and
will absorb the oils. This way the parts will not be coated again once the
cleaning is complete. We do not offer the cheese cloths or the oil diapers.
AUTOMATIC DEGAS /
SWEEP TECHNOLOGY
This unit has automatic degas and sweep technology, the first 5 minutes of usage.
The Degas will expel all the gasses and/or air out of the water in the tank, for better
cavitation for the ultrasonic power. The Sweep will move the cavitation around in the
tank in a more uniform fashion making the ultrasonic cavitation more efficient.
ON/OFF
