10
DRIVE TRACK AND BELT
SUPER E-Z BRUSHES
CHANGING DRIVE BELTS
With prolonged usage of the cleaner the Drive Tracks may stretch, or wear. To
maintain optimum performance they will require replacement. To
access the gear assembly it is necessary to
remove the cleaner’s Side Plate.
(1)
Remove the Bumper wheel
by removing the “C” clip
and then the locking
screw (FIG 3).
(2)
Turn the cleaner upside
down and remove the Bottom
Lid Assembly. Locate and remove the four screws
that hold the Side Plate to the main body. The Side
plate is now free and ready to be removed.
(3)
When the Side Plate is taken apart, you will notice 3
black bushings. It is a good idea to also replace these
Bushings when the Drive Tracks are replaced.
(4)
After the Drive Tracks and Bushings are replaced,
reassemble the Side Plate as shown here. (FIG 4)
(FIG 5)
\
To remove the drive belts, locate the small hole
on the outboard wheels (fig.#1) and remove
with a slot screwdriver. Repeat for all four
wheels.
Then remove the bolts and nuts from the Side
Plate (fig.#3) at four places. After you remove the Side Plate the interior assembly of the Drive Pulley, Idlers, and
Wheel Tubes will fall onto the work surface. Take note as to where the internal parts are located. Refer to the
picture above to see the way the Drive Belt is threaded through the Pulleys.
To Change Super Brushes for full length and “split” Wheel Tubes:
Using a pair of pliers, grab one end of the stainless steel Rod that is securing
the old Brushes onto the Wheel Tube. Pull away from the Wheel Tube slowly
until the entire existing Brush is freed and removed. Wrap the new Super
Brush around the Wheel Tube. Join the ends of the replacement Super Brush
using the Metal Rod supplied in the package. Slide the Rod through the Tabs
molded into the ends of the Brush. Make sure that
the Rod is inserted through every Tab.
fig.3
fig.4
fig.1
fig.5
DuraMAX
Duo
DuraMAX
Duo
DuraMAX
Trio
DuraMAX
Trio
DuraMAX
DuraMAX
DuraMAX
BiTurbo T2
DuraMAX
BiTurbo T2
DuraMAX
RC
DuraMAX
RC
DuraMAX
Duo Jr.
DuraMAX
Duo Jr.
OPERATING INSTRUCTIONS
