36
1 1 5 0 / 1 1 5 5 H A Y B U S T E R T U B G R I N D E R O P E R A T I N G I N S T R U C T I O N S
3.14 Starting and stopping the belly and discharge conveyors
The belly and discharge conveyors are on one circuit, so one control starts and stops both conveyors. The control is
found at the operator panel near the engine. Conveyors should be started before the rotor is started, and should be
allowed to run until the rotor stops turning.
NOTE: See also section 3.17, “Operating the grinder using the remote radio option
”
3.15 Lifting the discharge conveyor
The discharge conveyor can be raised or lowered as needed. There are two sets of controls for raising and lowering the
conveyor. One set of controls is at the operator panel and one set is at the rear left of the machine.
NOTE: See also section 3.17, “Operating the grinder using the remote radio option
”
3.16 Pivoting the discharge conveyor
The conveyor can be swung left or right as needed. There are two sets of controls for swinging the conveyor. One set
of controls is at the operator panel and one set is at the rear left of the machine.
CAUTION:
Make sure that no one is between the conveyor and the main frame before pivoting the
conveyor.
NOTE: See also section 3.17, “Operating the grinder using the remote radio option
”
