background image

SAFETY PRECA

SAFETY PRECA

UTIONS

UTIONS

When the safety precautions are followed, the
FireHammer MT will provide years of
enjoyment. Use care and good sense at all
times when operating this radio controlled
truck. Failure to use this vehicle in a safe,
sensible manner can result in injury or damage
to property.You and you alone must insure that
the instructions are carefully followed and all
safety precautions are obeyed.

Do not operate the FireHammer MT near
people. Spectators should be behind the
driver or at a safe distance away from 
the vehicle.

Water can cause the electronics to short
out and can cause permanent damage.

Always turn on the transmitter before
turning on the receiver.

Fully extend the transmitter antenna
before operating your vehicle.

Before turning on your radio system,
check to make sure that no one else is
running on the same frequency.

The engine and exhaust produce quite a
bit of noise. Do not run this vehicle when
or where it can disturb others.

The engine and exhaust can become
very hot. Avoid touching any of these
parts during use and until they have
cooled down.

Gasoline is extremely flammable. Keep
it away from open flame, excessive heat
or sparks. Do not smoke while operating
the FireHammer MT.

This engine was designed for R/C
vehicles and should not be used for any
other purpose.

The engine emits harmful fumes just 
like real vehicles. Do not operate this
model indoors.

Avoid running the truck in cold weather.
The plastic and metal parts can become
brittle at low temperatures. In addition,
grease and oil become thick, causing
premature wear and poor performance.

SPECIFICA

SPECIFICA

TION AND

TION AND

DESCRIPTION CHANGES

DESCRIPTION CHANGES

All pictures, descriptions and specifications
found in this instruction manual are subject to
change without notice. DuraTrax maintains no
responsibility for inadvertent errors in this
manual. Visit  www.duratrax.com for the
latest updates and information for your model.

STRESS-TECH

STRESS-TECH

P

P

AR

AR

TS

TS

GU

GU

ARANTEE

ARANTEE

We have engineered the FireHammer MT to
take the rough and tumble abuse that makes
R/C trucks fun. We are so confident of the
quality and durability of the Stress-Tech plastic
parts that we will replace any Stress-Tech
plastic part you break during the first 12
months you own the truck. Just send in the
part to us and we will send you a FREE
replacement. Please see the FireHammer MT
parts list for the items covered under the
Stress-Tech guarantee.

To receive your free replacement part
please send the following to the Hobby
Services address listed under the warranty.

1. The broken part must be included.

2. The part number and description of

the broken part.

3. Copy of your dated invoice or

purchase receipt.

4. Your name, phone number and

shipping address.

W

W

ARRANTY

ARRANTY

DuraTrax guarantees this kit to be free
from defects in both material and
workmanship at the date of purchase.
DuraTrax will warranty this kit for 90 days
after the purchase date. DuraTrax will
repair or replace, at no charge, the
incorrectly made part.

Make sure you save the receipt or invoice
you were given when you bought your
model! It is your proof of purchase and
we must see it before we can honor the
warranty. Further, DuraTrax reserves the
right to change or modify this warranty
without notice.

In that DuraTrax has no control over the
final user assembly or material used for
final user assembly, no liability shall be
assumed nor accepted for any damage
resulting from the use by the user of the
final user-assembled product. By the act of
using the user-assembled product, the
user accepts all resulting liability.

The engine is under a limited warranty for
3 years. DuraTrax warrants this engine to
be free from defects in materials and
workmanship for a period of three years
from the date of purchase. During that
period, DuraTrax will, at its option, repair or
replace without service charge any
product deemed defective due to those
causes. You will be required to provide
proof of purchase date (receipt or invoice).

This warranty does not cover damage
caused by crash, abuse, misuse,
alterations or accident. Damaged caused
by customer disassembly, tampering, use
of substandard fuel, use of incorrect

accessories (spark plug, etc) or any use
of the engine for which it is not specifically
intended will automatically void the
warranty of the engine. If there is damage
resulting from these causes within the
stated warranty period, DuraTrax will, at
its option, repair or replace it for a service
charge not greater than 50% of the
current retail list value. Be sure to include
your daytime telephone number and e-
mail address in case we need to contact
you about your repair.

Under no circumstances will the purchaser
be entitled to consequential or incidental
damages. This warranty gives you specific
legal rights and you may also have other
rights, which vary from state to state.

If you attempt to disassemble or repair this
unit yourself, it may void your warranty.

To return your FireHammer MT for repairs
covered under warranty you should send
your truck to:

Hobby Services

3002 N. Apollo Drive Suite 1

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am-5:00 pm

Central Time M-F

E-mail:

hobbyservices@hobbico.com

www.hobbyservices.com

If the buyer is not prepared to accept the
liability associated with the use of this
product, the buyer is advised to return
this kit immediately in new and unused
condition to the place of purchase.

REP

REP

AIR SER

AIR SER

VICE

VICE

Repair service is available anytime.

After the 90 day warranty, you can still
have your FireHammer MT repaired for a
small charge by the experts at DuraTrax’s
authorized repair facility, Hobby Services.

To speed up the repair process, please
follow the instructions listed below.

1. Under most circumstances return the

ENTIRE vehicle. The exception would
be sending in a Stress-Tech part. See
the instruction under the Stress-
Tech Guarantee.

2. Make sure the transmitter is turned off,

all of the batteries are removed and
the fuel tank is completely empty.

3. Send written instructions which include: a

list of all items returned, a THOROUGH
explanation of the problem, the service
needed and your phone number during
the day. If you expect the repair to be
covered under warranty, be sure to
include a proof of date of purchase (your
store receipt or purchase invoice).

THINGS 

THINGS 

T

T

O

O

KNO

KNO

W

W

3

Summary of Contents for FireHammer MT









Reviews: