29
29
23
ROLLER DOOR
roll-a-guide
bottom
rail
bottom rail lip
stop
To prevent clips from sliding down the guide, temporarily
secure them with adhesive tape.
B
C
guide
clearance
0.1mm
roll-a-guide
door
curtain
200mm
200mm
space
evenly
E
E
C
ATTACHING STOP
To attach bottom rail stops to bottom rail of door.
•
Hook stop behind lip in rail, as shown.
•
Secure from underneath the rail with screws supplied.
Trim the weatherseal fl ush with the end of the bottom rail.
GUIDES
•
Check that curtain overlaps equally on both sides,
and cut the guides (C) so that top of guide is the
same height as the top of the brackets (B)
•
Slide four guide clips (E) into each guide (C). Position the bottom clip 200mm from the fl oor with the
rest evenly spaced along the guide.
•
Position one guide over the edge of the door curtain. Mark and drill the top fi xed guide clip and secure
using 40mm x 8mm coach screw and washer, allowing 3mm clearance between inside of guide and
plastic Roll-A-Guide.Ensuring guide is plumb, fi x remaining clips.Repeat with 2nd guide.
•
•
•
•
•
•
•
•
Remove the wooden chock and slowly lower the door removing
plastic wrap as you pull door down, reposition the guides as necessary
to allow smooth and even operation with 0>1mm clearancet.
•
Ensure door curtain enters guides smoothly. It will be necessary to adjust the guide lead in to achieve
this.
nylofelt
guide lead in
