Rev.4
1
MACHINE SPECIFICATIONS
Also see machine layout for Power, Air and Water locations.
Power
(Standard)
Requires one electrical drop of 230V, 60Hz, single
phase
Requirements
(SEE ELECTRICAL SCHEMATICS FOR FLA)
(Optional)
Requires one electrical drop of 220V, 50Hz, single phase
(SEE ELECTRICAL SCHEMATICS FOR FLA)
Air
Requires one air drop: One 1/2” tubing (minimum)
with 3/4” NPT fitting,
Requirements
30 CFM at 80 PSI to the Form Fill & Seal Machine (total 30 CFM) Dry Air.
Water
Water supply with minimal pressure, ¼” tubing (maximum) with 1/8” NPT fitting to
Requirements
the Form, Fill, & Seal Machine. Recommended sediment filter and shut-off valve.
(Optional)
FILM & BAG SPECIFICATIONS
NOTES:
1. EYE MARK WILL BE 1/2" IN FROM SEAL - TOWARDS THE ROLL - REGARDLESS OF WHICH WAY THE ROLL IS WOUND.
2. EYE MARK TO BE DARK COLOR (BLACK PREFERRED).
3. TO INSURE THAT YOU HAVE THE PROPER LEVEL OF CONTRAST BETWEEN THE BACKGROUND AND THE EYE MARK,
A TEST MUST BE CONDUCTED. IF YOU HAVE ANY DOUBT ABOUT HAVING ENOUGH CONTRAST, SEND SAMPLES TO HAMER LLC.
4. TINTED FILM MUST HAVE CONSISTENT TINT LEVEL - VARIATION CAUSES MISFIRE.
5. THE FILM MUST BE ABLE TO UNWIND FROM THE ROLL WITH A FORCE OF NO MORE THAN 8 POUNDS.
6. NO PRINT ALLOWED WITHIN SPECIFIED DIMENSIONS.
7. NO COATINGS, TREATMENTS, OR FINISHES, ETC. PERMITTED IN "NO PRINT AREAS" ON BOTH SIDES OF THE BAG.
(SEALABLE SURFACE REQUIRED FOR BONDING OF HANDLE FILM)
8. SEE PATCH FILM SPECS IN YOUR MANUAL(S) FOR ADDITOINAL REQUIREMENTS FOR THE HANDLE(S).
9. SEE BAG SPECS FOR THE BAG LENGTH / WIDTH DIMENSIONS.
10. WHEN ADDING ZIPPERS AN ADDITIONAL 1-1/4" OF FILM IS REQUIRED FROM THE STANDARD BAG SIZE.
11. ZIPPER MODULES ADD 40" TO THE LENGTH OF THE STANDARD 540 / 535 FFS MACHINES.
12. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
FLAT BAG
WIDTH
14"-35" MAX.
*
1
1
2
" MIN.
*
1" MIN. BETWEEN PRINT
FLAT BAG
LENGTH
*
4" MIN.
Ø 20" MAXIMUM
*
EYE MARK
DETAIL
**
Machine with 6” Flex Fill Opening
Bag Width: Minimum:
10-3/4”
Maximum:
18”
Bag Length: Minimum:
14”
Maximum:
35”
Poly Thickness:
Minimum:
1.75 mil. Center Fold Film
Maximum:
4 mil. Center Fold Film
1.75 mil (minimum) Center Fold Film.
4 mil (maximum) Center Fold Film
Summary of Contents for Hamer 540
