600
600
2250*
0
1
2
L
N
PE
Electrical installation
II
I
* or the height of
the highest shower
head / water outlet
that is permanently
installed; depending
on which is higher
Safety areas in accordance with DIN VDE 0100-701
7xxxxx xx x xx xxx0: 50 Hz, 220 - 240 V AC
7xxxxx xx x xx xxx6: 60 Hz, 220 - 240 V AC
I
N
= 16 A
I
ΔN
≤ 30 mA
Power supply
Fuse protection
RCD
Pre-installation
> Installing a permanent power supply line:
•
Pre-connect a separate fuse and residual
current operating device (RCD)
•
Pre-connect an all-pole separating main switch
outside the prescribed safety areas (0 - 2)
•
Allow the supply line to protrude by 3,000 mm
> Laying the potential equalisation cable:
•
Allow the cable to protrude by 3,000 mm
16
Connecting the whirltub (Diagram 16)
NoTE! Avoiding any malfunctions!
•
Do not fasten the cables together with cable ties.
•
Do not install the supply line parallel to the control
cables.
I
Connect the supply line to the mains supply
socket.
II
Connect the potential equalisation cable to the
whirltub.
WH_M_D-Code_Panel_Magnets/16.04.2.
7
en
Summary of Contents for D-Code 7X0095
