22
6.4 control panel
>
Clean the control panel with a soft, damp cloth.
6.5 Drain cover
>
Clean the drain cover with a soft, damp cloth.
7. Troubleshooting Support
cAUTIoN
The whirltub may be repaired only by a qualified plumber and electrician.
Problem
Potential cause
Solution
Foaming
Soap or shampoo in the
bathwater.
Switch off the whirltub system.
Fill the tub with fresh water.
Whirltub system does not
start?
Mains switch is switched off.
Switch on at the mains.
Mains fuse is switched off.
Switch on the mains circuit
breaker.
Ground-fault switch (RCD) or
circuit breaker has tripped.
Disconnect the tub from the
mains.
Call customer service.
Motor-related noise after
emptying the tub
Any remaining water has
drained from the pipes.
Sound volume / quality can-
not be changed.
Data not compatible.
Check whether the audio source
supports the A2DP protocol.
8. Technical Data
8.1 Identification plate
The identification plate is on the back page of the operating instructions or in the tech-