en
About the mounting instructions
The mounting instructions come as part of the Duravit
integrated shower toilet and are aimed at people who
install the integrated shower toilet. You must read
through the mounting instructions carefully and they
must be available at all times.
Explanation of the signal words and symbols
DANGER
Indicates a hazardous situation
which, if not avoided, will result in
death or serious injury.
WARNING
Indicates a hazardous situation
which, if not avoided, could result
in death or serious injury.
CAUTION
Indicates a hazardous situation
which, if not avoided, could result
in minor or moderate injury.
NOTICE
Is used to address practices not
related to physical injury.
Link to the
Electrical Installation
section
Link to the
installation information
in this
section
Link to the
Water Installation
section
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks and leak-tightness
Rinsing
Target readership and qualifications
The integrated shower toilet and associated water
connection shall only be installed by qualified plumbers.
The electrical installation shall only be carried out by
qualified electricians.
WARNING
Risk of electric shock!
> The product must be grounded. Do NOT operate the
product without proper grounding.
> Connect only to a supply protected by a ground-fault
circuit-interrupter (GFCI).
> The GFCI shall be installed in a readily accessible
location for bathroom environment.
> Do NOT remove individual components.
> Connect the product only to the specified power supply.
> When working on electric components, disconnect the
power supply.
> Do NOT install the integrated shower toilet in
a room exposed to excessive moisture. Ensure
sufficient ventilation to avoid condensation in electric
components.
> When the integrated shower toilet is brought from a
cold location to a warm one, leave the unit switched
off for a few hours to avoid condensation.
> NEVER touch the power supply cable with wet hands.
Risk of electric shock, fire, injury to persons or product
damage!
> Local installation regulations, country-specific
standards and the Low Voltage Directives shall be
observed at all times.
Risk of fire!
> Keep product away from hot surfaces.
> Keep any flammable materials such as candles,
cigarettes or similar, away from this product.
Risk of injury and risk of product damage due to
impacts to ceramic!
> Avoid direct impact to ceramic as this may break.
> It is strictly forbidden to install the toilet base into
gel material (cement mortar), so as to avoid product
broken as result of expansion.
Risk of malfunctions and color changes!
> Only use the parts in the installation kit to avoid
malfunctions.
> Do NOT use attachments not recommended by Duravit.
> Do NOT expose the product directly to sunlight.
Risk of product damage due to freezing water!
> Do NOT install the integrated shower toilet in
rooms where there is a danger of frost. The room
temperature must not be less than 4 °C (39 °F).
4
57307_Mounting_SensoWash i_Lite_US/19.07.1
Summary of Contents for SensoWash i Lite 620000 01 1 40 1310
