321287
Instruction Manual
Duren Tools
T: 01582 484875 E: sales@duren.co.uk
www.duren.co.uk
Warranty
We hope that you will be very happy with your purchase. If you do have a problem with your tool, you have the
added peace of mind of a 6 month warranty, which comes into date from the date of purchase (proof of purchase
required).
Scope of Warranty
- The warranty will cover you from all faults cause by defective components or poor workmanship.
- Tools sent outside the EU are not covered by this warranty.
- Product must be returned to us, the warranty does not cover cost of carriage.
- If the product is no longer in manufacture, it will be replaced with a tool of equivalent or higher specification.
What is not covered
- Normal wear and tear caused by use in accordance with the operating instructions.
- Replacement of any provided accessories, such as Backing Pads, Carbon Brushes, Blades, handles
Spanners, etc.
- Accidental damage, faults caused by negligent use or care, neglect, misuse or careless operation, handling and
storage of the product.
- Modification of, or change of, any part of this product in any way.
- Faults caused by use of non compatible accessories.
- Tool seizure caused by insufficient servicing and maintenance.
- Faults caused by incorrect installation/assembly.
- Repairs or alterations carried out by non-approved parties.
Validity
- This warranty is valid for 6 months after date of purchase.
- Warranty is rendered invalid if;
- Tool is taken apart for any reason without our consent.
- The points in the Electrical and General Safety Instructions are not observed.
- A warranty claim will not be accepted without an official proof of purchase from your supplier.
Declaration of Conformity
We declare that the equipment detail below, to the best of our knowledge and ability, complies with the following
Directives.
2006/42/EC, 2006/95/EC, 2004/108/EC, 2011/65/EU
Equipment Description
240V Electric 150mm Dual Action Polisher
Part Code
321287
Distributed in the EU by
Duren Tools, a wholly owned subsidiary of Fast Mover Tools Ltd
Address
Unit 1 Frenchs Avenue, Dunstable, Bedfordshire, LU6 1BH, United Kingdom
The following Transposed Harmonised Standards have been applied in the
design and construction of this equipment:
EN 60745-1:2009+A11
EN 60746-2-3:2009+A11
EN 55014-1:2006+A1+A2
EN 55014-2:1997+A1+A2
EN 61000-3-2:2006+A1+A2
EN 61000-3-3:2008
The manufacturer and the distributor, stated above, hold the Technical Construction File for this equipment.
Signed on behalf of the distributor
(the responsible person)
…………………………………………
Name:
Brian Moffitt
Position:
Director
Date and Place:
28/05/14, Dunstable, UK
321287_Product Instructions 30/07/2014 08:42 Page 6
