Operating manual part II
© 2010 Dürkopp Adler AG
II-5
1.1.2 Technician-level
The technician's level is unlocked by the following key combination:
When switching on the control unit and press the P button
and the reset button
at the same
time.
This allows access to the technician's level.
Press A+ to get into the technician's level.
L
C
P
Min
Max
Preset Unity
Description
Backtack
t
00 00 300
2500
1000
rpm
Start backtack speed
t
00 01 0
254
5
10°
Pre-control angle when switching on the backtack magnet.
(Switchover of forward backward at the bartack)
t
00 02 0
254
17
10°
Pre-control angle when turning th e backtack magnet off.
(Changing of backward forward at the bartack)
t
00 03 0
1
0
-
Start backtack with the position 0 of the pedal interruptible.
0 = off;
1 = on
t
00 04 0
2
0
-
Mode for the end of the start backtack.
0 = You sew further after the end;
1 = Machine stops and must be started by the pedal again;
2 = Thread performance after the start backtack
t
00 05 0
1
1
-
Pedal release only to an additional route A
0 = off;
1 = on
t
00 06 0
500
0
ms
Delay time up to the speed release after the start backtack
t
00 10 300
2500
1000
rpm
End backtack speed
t
00 11 0
254
9
10°
Pre-control angle when switching on the backtack magnet.
(Switchover of forward backward at the bartack)
t
00 12 0
254
17
10°
Pre-control angle when turning the backtack magnet off.
(Changing of backward forward at the bartack)
t
00 13 0
1
0
-
Backtack magnet stays switched on (simple with the last
backward way final backtack and multiple backtack ends) till
the needle has been reached the Pos. 2.
0 = off;
1 = on
t
00 20 300
4000
2800
rpm
Start multiple backtack speed (only at the stuffing program)
t
00 21 0
254
16
10°
Pre-control angle when switchin g on the backtack magnet.
(Switchover of forward backward at the backtack) (only at the
stuffing program)
t
00 22 0
254
22
10°
Pre-control angle when turning the backtack magnet off.
(Change of backward forward at the backtack) (only at the
stuffing program)
t
00 23 0
1
0
-
Start backtack as a stuffing program.
0 = off;
1 = on
t
00 30 0
1
0
-
Ornamental backtack
0 = off;
1 = on
t
00 31 0
2500
1200
rpm
Ornamental backtack speed
t
00 32 0
1000
100
ms
Stop time at the ornamental backtack
