Working basis
Service manual 567 classic - 01.0 - 10/2015
15
3.3.7 Removing and installing the feed-dog
Fig. 7: Removing and installing the feed-dog
Removing the feed-dog
1. Remove the throat plate (
2. Loosen the screws (3).
3. Take the feed-dog (1) off the feed-dog carrier (2).
Installing the feed-dog
1. Place the feed-dog (1) onto the feed-dog carrier (2).
2. Tighten the screws (3).
3. Insert the throat plate (
Important
: Check the feed-dog position in its movement at maximum
stitch length (depending on the equipment: 6, or 9) by turning
on the handwheel. The feed-dog must have an even distance
from the throat plate. The needle must be positioned in the
center of the needle hole on insertion.
Order
Then check the following setting:
Feed-dog (
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch the sewing machine off before you remove
or install the feed-dog.
2
3
1
(1) - Feed-dog
(2) - Feed-dog carrier
(3) - Screws
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......