Setting the feed-dog
Service manual 567 classic - 01.0 - 10/2015
27
Basic position
:
The slot in the eccentric screw (3) is parallel to the setscrew (2), the
recess (4) faces the front.
If the forward and backward stitches are not the same length:
•
Turning clockwise
:
The forward stitch becomes larger, the backward stitch smaller.
•
Turning counterclockwise
:
The forward stitch becomes smaller, the backward stitch larger.
3. Tighten the setscrew (2).
9
Setting the feed-dog
The position and the movement of the feed-dog and needle bar have to be
coordinated such that the needle pierces exactly in the center of the nee-
dle hole of the feed-dog.
Order
First check the following setting:
•
Needle bar linkage (
10 Aligning the needle bar linkage
9.1
Setting the feed-dog position
Correct setting
The feed-dog is exactly in the center of the throat plate cut-out, both side-
ways and in the sewing direction.
If the stitch length is 0, the needle pierces exactly in the center of the nee-
dle hole.
Various settings can be made depending on how far the position of the
feed-dog differs from the correct setting:
•
For minimal deviations, it suffices to move the feed-dog on the carrier
(
•
If this is not sufficient, move the entire feed-dog carrier on the sliding
shaft
(
9.1.2 Moving the feed-dog carrier
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
feed-dog position.
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......