Setting the feed-dog
Service manual 567 classic - 01.0 - 10/2015
29
9.1.2 Moving the feed-dog carrier
The feed-dog carrier is connected to the stitch regulator gear via the
sliding shaft and can be moved on this shaft.
Cover
•
Tilt the upper section (
3.3.1 Access to the machine bottom section
Fig. 21: Moving the feed-dog carrier
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen the connection to the tie rod (1) on both screws, ensuring that
the adjusting rings are not twisted vertically.
3. Loosen the rear screw (6).
4. Loosen the setscrews for the adjusting rings (2).
5. Move the feed-dog carrier cross-line to the sewing direction such that
the feed-dog is exactly in the center of the throat plate cut-out.
6. Push the adjusting rings (2) toward each other as far as they will go.
Make sure that the sliding shaft (3) is tightened by the clamping rings.
7. Tighten the setscrews for the adjusting rings (2).
8. Move the feed-dog carrier in the sewing direction such that the feed-
dog is exactly in the center of the throat plate cut-out.
9. Tighten the rear screw (6).
10.Tighten the connection to the tie rod using the screws (1).
In the process, make sure that the feed-dog height has the correct
setting.
(
9.2.2 Setting the feed-dog height in the top dead center
1
2
4
3
4
6
5
5
(1) - Screws
(2) - Adjusting screws
(3) - Sliding shaft
(4) - Assembly frame
(4) - Plates
(5) - Screw
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......