Setting the feed-dog
32
Service manual 567 classic - 01.0 - 10/2015
9.2.3 Setting the stroke movement
Order
First check the following setting:
•
Feed-dog height (
9.2.2 Setting the feed-dog height in the top dead
Correct setting
At the front dead center (handwheel position 90°) and at the rear dead
center (handwheel position 270°) for the feed-dog, the upper edge of the
feed-dog is at the same height as the upper edge of the throat plates.
At 90°, the feed-dog is in the upward movement; at 270°, in the downward
movement.
Cover
•
Tilt the upper section (
3.3.1 Access to the machine bottom section
Fig. 24: Setting the feed-dog lift
Setting steps
1. Unscrew the setscrews (1).
2. Put the handwheel into the 90° position.
3. Turn the stroke eccentric (2) such that the upper edge of the feed-dog
is in the upward movement and at the same height as the upper edge
of the throat plates.
4. Tighten the setscrews (1).
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the stroke movement of the feed-dog.
(1) - Setscrews
(2) - Stroke eccentric
①
②
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......