Aligning the needle bar linkage
34
Service manual 567 classic - 01.0 - 10/2015
Setting steps
1. Position the stitch length adjusting wheel to 0.
2. Loosen the adjusting wheel for the sewing foot pressure (1):
3. Undo all 3 setscrews (2).
4. Remove the plugs of the openings (3).
5. Release the setscrews behind the plug/opening (3).
6. Move the needle bar linkage sideways such that the needle pierces
exactly in the center of the needle hole for the feed-dog.
7. Tighten the setscrews behind the plug/opening (3).
8. Insert the plugs in the openings (3).
9. Tighten all 3 setscrews (2).
10.Tighten the adjusting wheel for the sewing foot pressure (1):
Order
Then check the following settings:
•
Loop stroke position (
11.2 Setting the loop stroke position
•
Distance of the hook to the needle (
10.2 Aligning the needle bar linkage in the sewing direction
Cover
•
Valve cover (
3.3.4 Removing and fitting the valve cover
•
Tilt the upper section (
3.3.1 Access to the machine bottom section
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the needle bar linkage in the
sewing direction.
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......