Setting the bobbin housing lifter
Service manual 567 classic - 01.0 - 10/2015
43
12 Setting the bobbin housing lifter
Fig. 32: Bobbin housing lifter
The hook pulls the needle thread through between the nose of the spool
housing (3) and the recess in the throat plate (4).
The bobbin housing lifter (2) now pushes the bobbin housing (1) away so
that a gap appears for the thread.
If the hook tip is located below the bobbin housing lifter, then the bobbin
housing lifter must open so that the thread can also slide past in that
position.
So that the thread can slip through without a problem, the width of the
lifting gap and the timing of opening have to be set.
Faults caused by an incorrect setting:
•
Thread breakage
•
Formation of loops on the bottom side of the seam
•
Loud machine noise
12.1 Setting the lifting gap
Order
Always check the width of the lifting gap after making changes to the
needle thread size. The correct width of the lifting gap depends on the
thickness of the needle thread.
3
4
1
2
(1) - Bobbin housing
(2) - Bobbin housing lifter
(3) - Spool housing nose
(4) - Recess in the throat plate
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
width of the lifting gap.
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......