Setting the bobbin housing lifter
44
Service manual 567 classic - 01.0 - 10/2015
Correct setting
The needle thread slides through unobstructed between the nose of the
spool housing and the recess in the throat plate.
Cover
•
Tilt the upper section (
3.3.1 Access to the machine bottom section
•
Throat plate slide (
3.3.5 Opening and closing the throat plate slide
Fig. 33: Setting the lifting gap
Setting steps
1. Loosen the screw (3).
2. Push the cover (2) downwards.
3. Loosen the setscrew (1).
4. Set the spool housing lifter such that the gap between the nose of the
spool housing and the recess in the throat plate is just big enough to
allow the needle thread to slip through without a problem.
While doing so, ensure that the gap is not so big that the middle part of
the hook swings to and fro, hitting the recess in the throat plate.
5. Tighten the setscrew (1).
6. Push the cover (2) upwards.
7. Tighten the screw (3).
4
1
2
3
(1) - Setscrew
(2) - Cover
(3) - Screw
(4) - Bobbin housing lifter
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......