Winder
54
Service manual 567 classic - 01.0 - 10/2015
Removing the winder
1. Loosen the screws (1).
2. Remove the winder.
Setting the winder filling quantity
The position of the arms on the setting screw (2) determines the filling
quantity:
•
Parallel:
Automatic winding stop at 0.5 mm under the edge of the
winder
•
Closer together:
Automatic stop with larger filling quantity
•
Further apart from each other:
Automatic stop with smaller filling
quantity
3. Turn the setting screw (2):
•
For a larger filling quantity:
Turn it counterclockwise
•
For a smaller filling quantity:
Turn it clockwise
4. Put the completely filled bobbin onto the winder.
5. Fold the winder lever (3) upwards as far as it will go to the thread.
Fig. 44: Setting the winder spacing
Setting the winder spacing
6. Turn the winder spindle (12) such that the tear-off knife (11) is at the top
right and is facing the right-hand screw hole (13).
7. Loosen the setscrew in the clamp (5).
8. Set the winder lever (3) such that the upper arm is above the marking
for the XXL hook (15).
The distance between the winder lever and the outer thread on the
bobbin is 2 – 3 mm.
9. Set the clamp (5) such that it is resting against the locking disc (14).
10.Set the clamp (5) such that its distance to the winder wheel (6) is 0.5 mm.
Tighten the setscrew in the clamp (5).
6
^
<
+
5
,
3
(3) - Winding lever
(5) - Clamp
(6) - Winder wheel
(11) - Tear-off knife
(12) - Winder spindle
(13) - Right -hand screw hole
(14) - Locking disc
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......