Setting the feed-dog
Service manual 567 classic - 01.0 - 10/2015
31
4. Move the drive (3) forwards and backwards and observe the feed-dog
and needle in the process.
5. Turn the pusher eccentric (2) such that the feed-dog and needle no
longer move when the stitch adjustment lever (3) is pressed.
6. Tighten the setscrews (1).
9.2.2 Setting the feed-dog height in the top dead center
The feed-dog reaches the maximum stroke height at the top dead center
when the position of the handwheel is 190°.
Correct setting
Place the feed-dog in the uppermost position by turning the handwheel.
The upper edge of the feed-dog protrudes 0.5 mm above the throat
plate.
Cover
•
Tilt the upper section (
3.3.1 Access to the machine bottom section
Fig. 23: Setting the feed-dog height
Setting steps
1. Put the handwheel into the 190° position.
2. Loosen the setscrews (2) on the lever (1) at the left, above the hook.
3. Turn the lever (1) such that the upper edge of the feed-dog protrudes
0.5 mm above the throat plate.
4. Tighten the setscrews (2).
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before checking and
setting the feed-dog height.
1
2
(1) - Lever
(2) - Setscrews
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......
