Sewing feet
Service manual 567 classic - 01.0 - 10/2015
49
13.3 Setting presser foot pressure
The left adjusting wheel on the machine arm determines the pressure for
the sewing feet on the material to be sewn. The pressure can be adjusted
continuously by turning the adjusting wheel.
The correct pressure depends on the material to be sewn:
•
Lower pressure for soft materials, e.g. silk
•
Higher pressure for harder materials, e.g. leather
Correct setting
The material being sewn does not slip and is correctly transported.
Fig. 39: Setting presser foot pressure
Setting steps
1. Turn the adjusting wheel for the sewing foot pressure (1):
•
Clockwise
: more pressure
•
Counter-clockwise
: less pressure
13.4 Setting the sewing foot lifting height
When the pedal is pressed back halfway, the sewing feet can be raised
during sewing, e.g. to move the material being sewn.
When the pedal is pressed completely back, the sewing feet will be raised
after the thread is cut so that the material being sewn can be exchanged.
1
(1) - Adjusting wheel for the sewing foot pressure
WARNING
Risk of injury.
The sewing machine must remain switched on so
that the sewing feet can be raised.
Work very carefully when you check and set the lift-
ing height for the sewing feet.
Do not put your hands under the sewing feet when
they are being lowered.
Summary of Contents for 567 CLASSIC
Page 1: ...567 classic Service manual...
Page 20: ...Working basis 18 Service manual 567 classic 01 0 10 2015...
Page 79: ......