4.2
Needle bar height, play of needle to hook tip, loop stroke
Rule:
When the handwheel pointer indicates “
205
” degrees (2.5 mm loop
stroke), the hook tip should stand at the needle axis at the stitch length
0. Length
(A) = 1.5 mm
, clearance gap
(B) = 0.02 to 0.1 mm
.
–
Turn the handwheel so that the pointer indicates “
205
“.
–
Loosen screws (1). Turn the hook tip (2) on the needle axis.
–
Loosen screw (3). Position the needle bar with the needle to the
dimension (A). Tighten screw (3).
–
Loosen two screws (4) and screw (5). Move the hook column (6)
from the needle.
–
Tighten screws (4) gently. With the help of screw (7), move the
hook column (6) to the clearance distance (B). Tighten screws (4)
and (5).
–
Verify that the hook tip (2) is in the area of the needle axis.
Tighten screws (1).
26
3
1
5
A
B
6
4
2
7
4
