8
1)
Turn on the fan by pressing the power button on the panel. You can also turn
the fan on using the ON/SPEED button on the remote control.
2) Adjust the fan wind speed by pressing the ON/SPEED button on the
panel or
the
remote
repeatedly
until you achieve the desired speed.
3)
If you wish to set the timer, press the TIMER button to select the time you want
to set the fan to work for:
0.5hr / 1hr / 2hr / 4hr.
4) To make the fan oscillate/swivel side to side, simply press the OSC button on
the remote. To make it stop oscillating, press the same button again.
5) To turn the fan off, press the OFF button on the speed control panel
or on the
remote control.
U
s
i
n
g
t
h
e Fan
Before you start, empty the box contents and ensure that all the parts are
there according to the Fan Components List.
You will need a Phil
l
ips screwdriver for assembly.
1. First, you will need to separate the mesh covers
(1+6)
from the blades
as they are held together in the box with a temporary black plastic stopper,
the wall plate
(13)
and a spare screw.
S
et these aside until needed.
2. Place the motor unit/arm suppor
t (8+9)
flat on
to
a table facing
upwards.
3. Remove the blade stopper from the stem screw, and set aside.
4. Place the back mesh cover
(6)
onto the stem screw
(7)
, ensuring that
the pins align with the holes in the mesh cover.
5. Put on the cover
fastener (5)
and turn to tighten it in place.
6. Next, place the fan blade
(4)
on
,
ensuring that the two pins on the mesh
cover
fastener (5)
align with the
two
indents on the underside of the fan
blade.
7. Put on the blade fastener
(3)
and turn (anti-clockwise) to tighten
into place.
8. Place the front mesh cover
(1)
on top of the back mesh cover
(6)
, and
secure in place using the shroud ring
(2)
. You will need a screwdriver
to do
this.
9. Use the wall plate
(13)
and wall plate fixings
(14)
to install the fan onto
the wall.
Please note:
• You may need different raw plugs if installing this fan onto a plasterboard
wall. These are not included in the box. Please check and use the correct
raw plugs to ensure the fan is securely and safely fitted onto the wall.
• If you wish to install the fan by connecting the power to a fused spur
socket, installation
should
be done by a competent/qualified electrician
only.
How
to
Set
Up
Your
F
a
n
Summary of Contents for FN55
