Duronic MPS, Manual

6

7

Before Installation

Methods of Installation

Carefully unpack the screen

-When handling the screen, always keep the projector screen at a level

position on a clean surface.

- In order to protect the screen from exposure and stains, keep the

screen away from dust and liquid.

-Mark the location of where the screen will be installed

NOTE: Never pull the screen out of the case before the screen in

installed. If you do the screen could become damaged and your warranty

will be void.

Wall mount

- The screen can be wall-mounted with the fixings 

provided. Use the holes to mark the desired position 

on your wall. (Ensure that the wall is clean and dust 

free)

-Mount the screen from the key hole located on the 

back of the screen’s left and right end cap.

Tripod Mount

-The screen can also be used on a tripod

Ceiling Mount

-Put screws through the mount and into the ceiling

Operating Instructions

Extending the screen

-Extend the screen slightly out from the case using the handle. When you

reach the desired height, gently tug the screen downwards a little and

the screen will automatically be locked into place.

Note: If the screen fails to lock into place, repeat the tugging motion

until it is locked.

Retracting the screen

To retract the screen back into the case, simply pull the screen down

slightly and release the locking catch on the roller. The screen will

automatically roll back into the case by itself. Do not let go of the

screen, rather slowly guide it into the case. This will protect the screen.

CAUTION

Make sure that the screen is extended from the casing gently.

Make sure you retract the screen back into the casing after use. Failure

to do so may result in damage to the locking catch.

Retract

Extend