E-7
RADIO MEMORY (STATION PRESET MEMORY STORAGE)
- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE
STORED INTO ONE OF THE MEMORY POSITION.
- PRESS MEM./PROG. KEY ONCE.
- PRESS NEXT OR BACK KEY TO SELECT DESIRED MEMORY POSITION.
(THER E ARE 30 MEMORY POSITIONS).
- PRESS MEM./PROG. KEY ONCE TO SAVE THE SELECTED STATION INTO THE
SELECTED MEMORY POSITION.
- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS THE FM RECALL KEY, THE SAVED
RADIO-BAND WILL BE RECALLED.
- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO
THE SAME MEMORY POSITION.
OPER ATION OF RADI O
- PRESS THE "ON/STANDBY" KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE FUNCTION KEY REPEATEDLY UNTIL THE DISPLAY SHOWS "FM".
- TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE AND
ADJUST IT'S POSITION.
- USE THE “PLAY/ PAUSE” KEY TO SELECT THE DESIRED MODE (FM MONO/STEREO).
IN SOM E CASES, WHERE RECEPTION IS POOR, IT MAY BE ADVISABLE TO SELECT
“MONO” MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL.
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- PRESS (AND IMMEDIATELY RELEASE) THE NEXT KEY OR BACK KEY TO “SCAN”
(MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN” BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED
INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- PRESS AND HOLD (FOR 2 SECONDS) THE NEXT OR BACK KEYS TO “SEEK”
(AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN” TO THE NEXT
AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE
“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
INSERTION & REMOVAL OF DISCS
- WHEN OPENING THE CD-DOOR, ALWAYS ENSURE THE DISC IS NOT IN MOTION
(NOT SPINNING) WHEN YOU OPEN THE CD-DOOR. ALWAYS PRESS “STOP” BUTTON
TO STOP THE DISC SPINNING FIRST.
- PLACE A CD INTO THE COMPARTMENT WITH THE LABEL-SIDE (PRINTED SIDE OF
DISC) FACING UPWARDS. PRESS DOWN IN THE CENTER PART OF DISC UNTIL THE
DISC “LOCKS” ONTO THE CENTER SPINDLE.
- WHEN THE CD HAS BEEN PLACED ONTO THE CENTER SPINDLE, GENTLY LOWER
THE CD-DOOR DOWNWARDS UNTIL IT LOCKS SHUT.
- THE CD IS NOW READY TO BE PLAYED.
E-8
NORMAL CD OPERATION
- PRESS "ON/STANDBY" KEY TO SWITCH ON THE UNIT.
- INSERT A CD AS DESCRIBED.
- PRESS THE "FUNCTION" KEY REPEATEDLY UNTIL THE DISPLAY SHOWS "CD"
- THE DISK WILL START SPINNING & THE FIRST SONG (TRACK) WILL START PLAYING.
THE DISPLAY WILL INDICATE THE CURRENT TRACK NO.
- AT ANY ANYTIME DURING PLAYBACK, PRESS THE PLAY KEY TO PAUSE OPERATION
OF THE UNIT. PRESS PLAY KEY TO RESUME OPERATION AT THE SAME TRACK &
POSITION.
- AT ANYTIME DURING PLAYBACK, PRESS THE STOP KEY TO STOP OPERATION OF
THE SET. THIS WILL RESET THE SET TO THE FIRST TRACK (IF YOU PRESS
PLAY AFTER STOP, THE FIRST TRACK WILL ALWAYS START PLAYING).
- AT ANYTIME DURING PLAYBACK, PRESS AND RELEASE THE NEXT OR BACK KEYS
TO SKIP FORWAR D OR BACKWARDS BY ONE TRACK, AS DESIRED.
- ANY ANYTIME DURING PLAYBACK, PRESS AND HOLD THE NEXT OR BACK KEYS
TO FAST-FORWAR D (CUE) OR FAST-REVERSE (REVIEW) THE SPECIFIC TRACK,
WHICH IS CURRENTLY PLAYING.
- TO REMOVE A DISC, FOLLOW THE SAME PROCEDURE AS DESCRIBED ABOVE,
EXCEPT TO REMOVE THE CD INSTEAD OF INSERTING IT INTO THE COMPARTMENT,
BY PLACING ONE FINGER AT THE MIDDLE OF DISC (CENTER SPINDLE) & THE
OTHER AT THE EDGE OF THE DISC & GENTLY PULLING UPWARDS.
- IMPORTANT : ALWAYS HOLD A CD BY ITS EDGES. AVOID GETTING ANY FINGER
PRINTS, SMUDGES OR DIRT ONTO THE SURFACE OF A DISC. IN CASE THIS
HAPPENS, USE A SPECIAL CD-CLEANING CLOTH OR CLEANING KIT TO REMOVE
THE DIRT OR SMUDGES.
- THE CD PLAYER CAN BE PROGRAMMED TO PLAY ANY SEQUENC E OF UPTO 20 TRACKS
FOR REGULAR CD-AUDIO DISCS & 99 TRACK FOR MP3, AS DESIRED.
- ALWAYS PRESS THE STOP KNOB BEFORE STARTING THE PR OGRAMMI NG.
- PRESS THE MEM./ PROG. KEY, THE DISPLAY WILL SHOW A MEMORY SYMBOL
AND THE DISPLAY WILL SHOW “ ” , TO INDICATE THAT THE SET IS NOW IN
"MEMORY PROGRAMMI NG MODE ", AT MEMORY POSITION NO. 1.
- PRESS THE NEXT/BACK KEYS OR TO SELECT THE TRAC K (SONG) NUMBER
YOU WISH TO BE STORED IN THE FIRST MEMORY (PROGRAM) POSITION, AND PRESS
THE MEM./ PROG. KEY TO CONFIRM YOUR SE LECTION.
- WHEN YOU PR ESS MEM. / PROG. KEY THE DISPLAY WILL ADVANCE TO THE NEXT
MEMORY POSITION NUMBER (EG. “ ” FOR 2ND POSITION).
- REPEAT THE PREVIOUS 2 STEPS, EACH TIME SELECTING ANY TRACK NUMBER OF
YOUR CHOICE TO BE STORED IN THE SUCCESS IVE MEMORY (PROGRAM) POSITIONS.
- AFTER EACH TRACK NUMBER, REMEMBER TO PRESS THE ME M./ PROG. KEY.
- AFTER A MAXIMUM OF 99 SONGS (OR LESS) HAVE BEEN SELECTED AS DESCRIBED
ABOVE, PRESS THE PROGRAM KNOB.
- ALSO, THE MEMORY SYMBOL WILL REMAIN "ON" TO INDICATE THAT YOU
HAVE SAVED A PROGRAM- MEMORY (SEQUENCE).
- PRESSING PLAY WILL NOW PLAY BACK THE "SAVED SEQUENC E" IN
THE PROGRAM MEMORY.
- PRESSING NEXT/ BACK WILL MOVE TO THE NEXT OR PREVIOUS SONG
IN THE SAVED SEQUENC E.
- TO CLEAR (CANCEL) THE ENTIRE PROGRAM WHICH IS STORED IN THE MEMORY,
SIMPLY PRESS "STOP" TWICE, OR SWITCH "OFF" THE SET.
PROGRAMMING THE CD-PLAYER
P0 1
P02
