8. Screw-in needle guide (1).
9. Insert the pressure disc.
10. Insert the compression spring.
Fig. 21: Removing the needle gland
11. Insert the needle gland (1) and tighten
it.
9
Disassembly and Disposal
9.1
Safety recommendations
WARNING!
Risk of injury due to escaping material
and compressed air
Escaping compressed material can cause
serious injury.
Before carrying out any work:
– Disconnect the system, in which the
spray gun is installed, from com-
pressed air and material supply.
– Secure the system against reconnec-
tion.
– Relieve the lines.
9.2
Disassembly
Personnel:
Operator
+ additional qualification explosion pro-
tection
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
2. Avoid contact with the material and dis-
pose of material professionally.
3. Disconnect compressed air supply.
4. Clean the spray gun.
9.3
Disposal
ENVIRONMENT!
Incorrect disposal
Improper waste disposal threatens the
environment and prevents re-use and
recycling.
– Always dispose of components in
accordance with their characteristic.
– Collect leaked out operating and auxil-
iary materials completely.
– Dispose of operating and auxiliary
materials according to the disposal
provisions in force.
– In case of doubt, refer to the local dis-
posal authorities.
10
Technical data
10.1 Weight
Detail
Value
Weight without cup
490 g
Disassembly and Disposal
05/2018
EcoGun 910 - MSG00003EN
21/32
